Role of wire-to-wire connectors
In our daily life, safe electricity is very important, because there are many potential dangers when using electricity, we need to pay special attention to, if used improperly, it will lead to dangerous accidents at the wire junction, many wire accidents occur, part of the wire overload caused by the other part is caused by the loose wire connector, therefore, the wire connector is small, But it plays an extremely important role in circuit engineering. Its products are used in automotive, communications, consumer electronics, data processing, industrial machinery and many other fields, as well as for auxiliary circuits, and ampeconomympower(EP) wire-board connection system is designed for auxiliary circuit applications.

When we decorate water and electricity, the electricity union prepares wires, junction boxes, wire tubes, wire joints and other products. For the wire connector, many owners are not familiar with it, so how to use it? What does the wire-to-wire connector do to the installation of the wire? Here is an introduction.

1. In fact, the use of this wire connector is very simple. We strip the insulation layer of the wire about 10 mm according to the calibrated length, then lift the lever, put the wire into the connector, and loosen the lever. Compared with the method of connecting with electrical tape, connecting the wire with the connector is safer and more reliable, and the operation is simpler and more convenient. It has the advantages of flame retardant, voltage resistance, insulation, simple operation, solid connection, direct current transmission between wires, strong versatility, long service life and so on.

2. In the renovation of indoor circuits, wires generally walk the wall, but when we wire the kitchen and bathroom, we should walk the wall and the top of the circuit. The ceiling of the bathroom and the kitchen can not be slotted, so everyone will install the line on the ceiling, covered with the ceiling, when we slot the circuit, we should pay attention to not to slot the load-bearing wall, the wall should be vertically slotted, if the wall needs a vertical slot, the length of the horizontal slot should not exceed 30cm.

3. When the circuit is reformed, there shall be no joint in the wire tube. If you need wiring, you can complete it in the junction box, because strong and weak electricity are not the same, wear the same wire tube to be wired separately, maintain a distance of 500mm, to avoid electromagnetic interference of strong electricity on weak electricity, in the circuit layout, we also need to consider the use of household appliances, appropriate line capacity, and to reserve some switch sockets, In order to avoid the increase of electrical outlets in the future is not enough.

Wires are widely used, such as elevators, electric water heaters, children's toys, artificial intelligence and other commonly used products in life, not only cables, many engineering equipment fields have this wire connector, with this wire-to-wire connector, you can replace accessories at any time, extend the service life, in the future development, wire connector is a very important device, It facilitates the performance of the instrument and realizes multi-function.